Hello to All,
Here is another one of my Humpback Hunters.
The Blade is CPM 154 CM .141 thick and 3.625 from tip to bolsters, and O/A is 8.25. It has been heat treated to 60-61 rc with a cryo quench and tempered twice for two hrs. The blade was polished and then brush finished to 1200 grit. The tang has a nice tapered tang. I added an angle file pattern for thumb placement and for looks. I think it looks good anyway. This handle design is very comfortable.
Bolsters are dovetailed nickel silver pinned and soldered with total saturation of solder, and NO!! pin holes.
Handle is Ironwood that has a lot of chatoyancy, red liners, Corby rivets, and lanyard hole.
I will build the sheath upon request either Right or Left hand, two tone or one color, basket weave, fish scale, or groovy grooves.
Asking $295.00 with custom sheath, and $15.00 conus shipping. Thank you for looking. Alan