Just finished my first chisel grind blade.
3/32 1095 steel
3.75 in blade
7.5 in overall
Green canvas micarta handle with black liner.
Sent from my SAMSUNG-SM-G890A using Tapatalk
I use a cut up sleeping mat from Walmart in mine.
Is it pretty thin? Do you wrap and then wet with epoxy, or do you wet the twine and wrap wet?
When you make your peace with authority, you become authority.
I've done all scandis so far.. This is my first flat grind. I managed to sand through the top of the plung line. Also, knowing I would destoy the edge if I attempted to use my belt grinder free hand, I decided on my edgepro. Worked fine except I created a high spot where a bit to much pressure was used. 1084/ 5/32 8 1/2 inches
Sent from my iPhone using Tapatalk
Last edited by rjedoaks; 01-11-2017 at 05:36 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)