Also, $13 for 5 Big Macs and 5 Large Fries at McDonalds. http://www.livingsocial.com/cities/1...-5-large-fries
That is cold but looks like its going to be a real nice day here. The wind is gone and no clouds so far this morning.
Are you bulking right now? lolOriginally Posted by MRpink;10242994
Also, $13 for 5 Big Macs and 5 Large Fries at McDonalds. [url
Dang, that is cold Ban. Hope you brought enough layers
Harbor Freight is officially open now in San Jose, across from Oakridge.
Yep, you should pick up a little grinder. Makes heavy profiling and general knife edge maintenance much quicker and easier. Couple of decent belts and you will be set for a while.
I'm definitely looking to pick up a little grinder and some belts... It seems like they'd make my life so much easier. This one would be good enough right?
Hey, btw, what's a good refill for my Miltac pen? The one I have doesn't write very well.
I checked out the Zebra 701s at office depot and they are pretty decent. I much prefer the stainless sharpie for a cheap disposable kubaton.
Yeah, that grinder should be enough for sharpening and profiling. I am not that familiar with the selection of belts for 1X30s but I am sure trugrit will have them.
Not sure about the refill for the miltac pens.
Stainless steel sharpie looks nice, I'm going to have to check it out.
1x30 is fine for sharpening/reprofiling, has the basic essential belts from low grit ceramics to leather belts.
Sweet pics Russ..wish I coulda made it.
Hmm I might take a trip down to the Santa Clara Harbor Freight today and see what they have.
Just finished building this 10/22 Razor in 17HM2. 10/22 razor receiver with mainly stock ruger parts, Hogue Stock, 16" Whistle Pig Bull Barrel in 17HM2, and Fujinon 3.5-10X scope. The scope is sitting a skosh higher than I would like but I can live with it. Don't really feel like ordering new scope rings right now. Been sitting on this project for way too long. Can't wait to hit to range to sight it in.
Last edited by Ban; 12-05-2011 at 01:52 AM.
There are currently 1 users browsing this thread. (0 members and 1 guests)