Separate names with a comma.
This will be 15n20 and probably 1080 or close. We'll be rolling soon... I may make more CruforgeV damascus too, available from JT or directly...
Non stainless, yes. 15n20 and most likely 1080... as for contrast, that's up to the finish and etch process, but the potential will certainly be...
As Jarod says, he's leveling up in a few ways... the new cutter is exciting for sure! I'm looking forward to providing good clean damascus, in...
Extremely cool. Eastern Washington is the best place to live and work! Thanks for the look at your new site. Keep us posted!
Hey Kevin, wanted to say thanks again... that's an empowering thing you did for the community. I've been running my Powers disc now for several...
First, the HR150A is a good tester. I have one and it works well- just not below about 40f. Second, no RC is not the be-all end-all...
Well, of course you can check if the diamond indenter is installed on it for "C" scale... and look around for anything obviously broken. Beyond...
Zombie thread... for good reason though. I made one of these back in like 2015 or so, and was just trying to pass the .dxf file along to a friend...
In response to an earlier question, I make 410SS/CruforgeV san mai with no problems, at 2150f to weld. In fact that's currently my default...
Knowledge bombs dropping heavy here... a veritable knowledge blitz! Thanks for the info.
It can be done, using the same pencil trick, or just by rubbing the scales to the steel and then inspecting for small shiny spots on the wood,...
Interesting that you have categorized 52100 and even CruForgeV as primarily fast-oil steels. I always understood that Parks 50 was a little...
(From his website.) :rolleyes::rolleyes::rolleyes: My guess is he'll remain thirty years in the future, too... I just don't reckon we'll ever...
I like to add a threaded extension, myself. That way if I want to, I can add threads larger than the tang thickness would allow. Not really what...
That's genius! I like the way you think.
What I usually see said about the Baron is that the website is a poor way to shop with him... calling gets better results.
Very cool! Thanks for posting.
Unless you are Steve Filicietti. As far as advice, I can only echo what's already been said... waste rates vary greatly dependent upon pattern,...
Yes, 50-55 would be good!
I run a woodstove all winter and try to keep the temp inside my shop no lower than 40f at night, and considerably higher after stoking the fire in...
