Separate names with a comma.
There are two types of firebrick One is Heavy One is Light Believe it has to do with the heat rating
Light ones work well! Just sayin
Says the top temp is 2K No 1100f is too low
Have the opportunity to get an Kerr 900 Insultherm oven... Wondering if it would be good enough to do HTs?...
Stacy Sent you a message Not moving related Would gladly help if you were close to AZ
Have had that happen to me a few times... Probably old dry wood
What helped was to: Use a new drill bit for ea size hole
Go SLOW and back out...
Mcmaster Carr has some good quenching oils and can be bought by the gallon
Sharp AO belts are the way to go Middle to slow speed
Mused about how to do this for years Thanks for the solution!
Really like the detail of how the pins are all the same direction...
Can this be run on 110?
Thickness on #5 thru 13
Center line on thin stock?
Specifically what is a good way to scribe a center line for a .100 kitchen blade ...
Never used this thin of stock before
Bond time VS Cure rate
K&G 24 is the best I ever used. Tested it and destroyed the knife throwing it into a tree Handle finally broke the Epoxy...
This is what I mean:
Help figure this out... Hollowgrind?
So finally realized that an 8" wheel will do a nice hollow grind spine to edge on a 1" wide blade
Maricopa has some great things happening in the next few years
Welcome to AZ
Moved away 4 times and always come back
Every time I used a waterjet service they did the patterns at no charge provided I did a Min amount
Your millage will vary depending on the...
What might last is leaving the flats rough Hot Rolled 1075 doing the grind HT etc... Then edge in water and Heat color the spine using Map gas in...
Try here for your bandsaw blades: https://www.mcmaster.com/band-saw-blades/for-use-on~stainless-steel/
Your bandsaw HAS to be able to run...
You will be cutting Tool steel Which type of bandsaw do you have?
That's the potential issue here... Otherwise Yes you seem to have a solid plan