Cliff Stamp
BANNED
- Joined
- Oct 5, 1998
- Messages
- 17,562
Yesterday, thanks to Murray Haday, a Project I arrived, one thing that I noticed immediately was that the edge grind is very acute. I quick measurement confirmed this with the blade being .035" behind the bevel which is .075" wide. Now it varies some along the bevel, but not by much. The bevel also appears to be slightly convex (approximating it at v ground would give a grind angle of about 13 +/- 2 degrees). Is this a typical grind?
-Cliff
[This message has been edited by Cliff Stamp (edited 04-18-2000).]
-Cliff
[This message has been edited by Cliff Stamp (edited 04-18-2000).]