Emerson A100 Need some HELP

[mr2blue]

Steve,

If this is not OK just delete.
I have talked to Steve about making me a lowrider clip for an Emerson A100. I am hoping someone can measure the distance from the centerline of the 2 outside screws that hold the clip, to the end of the knife on the clip side.

This way I can order the clip going while the knife is enroute.

Thanks

 

[STR]

Sure this is fine. All I need is to know where to make the fold over. So from the mid line of both the widest set screws to the top of the knife plus or minus a few mm is fine. I would rather undershoot it by a tad than to overhang the end of the clip off the end of the folder. I only do that if someone asks for it usually.

Thanks

STR

 

[mr2blue]

Steve,

It is in UPS. I will send measurements as soon as it gets here.