Catch / release
Ontario spec plus gen 2 lot.
SP1: lightly used to carve 2 sticks , cut paper and open a few bags of dog food. Edge has been touched up on a ceramic rod and stropped, its sharp. IMHO this is a good alternative to the ka bar , you can actually Batton with it and it’s probably not going bend or break (due to a .20 thickness with a bigger tang than a ka bar).
1095 steel, unsharpened clip, factory sheath.
SP45: Never used on anything besides paper, para cord and a shoe lace. This one has been stropped with a fine ceramic rod and leather, razor sharp along all 8.5 inches of edge. I used a heat gun to gently mold the sheath’s liner , no rattle , no blade dragging its edge , better retention.
5160 spring steel , 3/16 x 8.25 blade.
Very light cutting , slashing and carving monster.
SP50: chopped into a 2X4 one time and it bit 1/4 through. Finish shows the slight marring , could probably be wiped off. Absolutely no edge deformities or chips. This one was lightly touched up on a spyderco sharpmaker. Will make a great light weight brush knife or big utility blade.
5160 spring steel , .25 thick x 9.5 blade , full flat grind .
The sheath on this one is missing 1 of the 2 button snaps but I’ll include some new para cord that can be looped through the Eyelets if you like.
These are oiled, wrapped, boxed and ready to go.
All knives sold together as a lot , not interested in selling individually right now (unless buyer pays fees and shipping).
Great set of users here. Beat them.
Asking $ 120 via PayPal
Shipping and fees included in my price.
USA shipping only on these.
Please ask any questions.
Please respect you local laws / 18+ only.
Thank you for reading my rant.
THANK YOU BLADE FORUMS!
Last edited: