Post your CRK carry knife for today.

Joined
Jun 25, 2015
Messages
852
RNA0e0i.jpg
 
Joined
Jan 8, 2017
Messages
503
a1c915dcec599621ba573ceced5a6811.jpg



Sent from my iPhone using Tapatalk

Hey CBKing, could you tell us a little more about the machine you have there? Maybe more pictures? I've been around the industrial world all my life and while it looks like a drill press of some sort, I'm not familiar with the gauge and what exactly is going on there.
 
Joined
Nov 10, 2014
Messages
273
Hey CBKing, could you tell us a little more about the machine you have there? Maybe more pictures? I've been around the industrial world all my life and while it looks like a drill press of some sort, I'm not familiar with the gauge and what exactly is going on there.

It's a old Bridgeport that is set up with a vise for hanging longer parts off the edge of the table. I was just simply drilling and tapping holes in the end of the part. The parts in this case were to long at 21 inches to fit in the CNC machines so this is how we have to do them. In this picture I had just set up a part and I was checking with an indicator to make sure the part was fully in the vise. It is a very similar machine to the one I pictured below our vise set up is just a bit different and our machine has a prototrak control on it that controls movement of the machine so you are not required to hand crank it to all the positions.

e76ab33bc0dff2183efbda4b0e0efc84.jpg


Sent from my iPhone using Tapatalk
 
Top