From an earlier post I was initiating a project to remove a logo from
a blade of VG10.I used a small round diamond tip to do the initial
cutting.This was followed smoothing it out with a norton fine india wheel.I polished it off with a buffing paste and a felt wheel.You can tell that it has been modified because of finish to that area but it is smooth and clean.
a blade of VG10.I used a small round diamond tip to do the initial
cutting.This was followed smoothing it out with a norton fine india wheel.I polished it off with a buffing paste and a felt wheel.You can tell that it has been modified because of finish to that area but it is smooth and clean.