Spyderco mods

[JBE]

Steve,

Here's what I'm looking to do.

1. SE Salt 1 - would like it waved.

2. Police 3 - Replace the thin black G10 handle slabs with something maybe a wee thicker if possible in either dark blue, blue/black or dark purple G10.

Thanks! I'm a long-time member over at the Spyderco website forums and was referred to you by several other members.

 

[STR]

Ok I can do that. I have a standard work order form top the page in two sticky threads I started. Just got to either the low rider clip thread or the 'Read this to mail me work" thread and fill out and print the work order form and mail. Its that simple.

$30 on the Wave, $65 on scales. I'd go with something textured if it were me but problem is I don't have anything but Ranger Green, Coyote Brown, and Black in textured G10. I do have some orange textured G10 in .080 thickness but I doubt that is much thicker if as thick as what is on it.

Be advised that the hardware on that folder will have to recess deeper if I go with noticeably thicker scales but I can adjust it in most cases.

Thanks for asking. Once you've printed up the work order mail at your convenience. I take things in the order its received and most things get in and out in good time. I do have a lot going on usually this time of year but so far its managed quite well.

STR