Little 3V project

[jdm61]

I have had a pile of water jet cut 3V blanks lying on the bench for a while and I finally finished one up.
.177 stock at 60Rc. The blade is 4 inches by 1 3/16 with a decent taper. The tang is skeletonized. The handle is stabilized koa done in a "Michelob bottle" profile with stainless Corby bolts and lanyard tube. Hand rubbed finish with a Treestump sheath that has been pants for a "shop"knife for a while.

 

[The Amazing Virginian]

Nice, Joe. Thanks for sharing.

 

[jdm61]

Thank you, kind sir. Like said, I have a pile of these and am working on ones amboyna burl, Oregon maple burl, blackwood, walnut and blackened green canvas Micarta. I may also do one in ancient Kauri.