Henry Cambron
www.worldclassknives.com
- Joined
- Nov 30, 2006
- Messages
- 218
This one is going to a bladeforums member in Connecticut. The etched finish on the blade is very tough.
A wire wheel on the buffer will remove stains, rust, etc. and not harm the finish.
Made From 3/16" 1095 High Carbon Steel, Blade Is Acid Etched & Flat Ground.
Appx. 5 1/4" Overall, Cutting Edge Is Appx. 2 1/2".
Green G11 Scales With Two 1/16" Brass Pins.
Handmade Leather Neck Sheath With Small Belt Loop For Additional Carry Options.
There Are 2 Computer Hard Drive Magnets Embedded In The Sheath To Aid In Blade Retention.
A wire wheel on the buffer will remove stains, rust, etc. and not harm the finish.
Made From 3/16" 1095 High Carbon Steel, Blade Is Acid Etched & Flat Ground.
Appx. 5 1/4" Overall, Cutting Edge Is Appx. 2 1/2".
Green G11 Scales With Two 1/16" Brass Pins.
Handmade Leather Neck Sheath With Small Belt Loop For Additional Carry Options.
There Are 2 Computer Hard Drive Magnets Embedded In The Sheath To Aid In Blade Retention.
Last edited: