110 Lt add on pocket clip

[bucklife301]

Just messing around and found a pocket clip that fits on the Lt perfect also fit the 112 Lt. It came off a old gerber 400 pocket knife had to use a longer screw. I know you can get the slim edc with a pocket clip but I was just messing around .

 

[jbmonkey]

like it. well done, Sir.

 

[st8yd]

Looks like it was made for it, but what keeps it from spinning?

 

[plb]

Looks good. Too bad my Gerber 400 is missing its clip. If are going to leave it on, you could drill and countersink the screw head flush with the handle.

 

[jazzz]

Nice.

 

[bucklife301]

Looks like it was made for it, but what keeps it from spinning?

Thanks when the screw goes in the threads it spreads the plastic and tighten it down you can get it to twist if you try but it want on accident.

 

[Brhowser87]

Thanks when the screw goes in the threads it spreads the plastic and tighten it down you can get it to twist if you try but it want on accident.

I was wondering the same thing. It looks great, like it came that way.

 

[RevolverGuy]

Looks great but how is the retention? I wish Buck would sell a clip as an accessory for these. I like the fuller size more than the slims and would pocket carry if I could.

 

[bucklife301]

Looks good. Too bad my Gerber 400 is missing its clip. If are going to leave it on, you could drill and countersink the screw head flush with the handle.

Yeah the screw that went on the gerbers were countersunk I’ll probably find a different screw later that sits more flush but this will work I don’t want to drill on the knife

 

[bucklife301]

Looks great but how is the retention? I wish Buck would sell a clip as an accessory for these. I like the fuller size more than the slims and would pocket carry if I could.

Retention? What’s that LoL

 

[st8yd]

Yeah the screw that went on the gerbers were countersunk I’ll probably find a different screw later that sits more flush but this will work I don’t want to drill on the knife

Ya and if you cant find one you could grind a little more taper off the screw.