- Joined
- Apr 2, 2010
- Messages
- 107
OK. I'll admit, I'm new, but this seems really strange to me.
I just bought a 2x72 Grizzly grinder with a 10" wheel. I set it all up with the provided belt, no problems.
I ordered some other belts for it and found I had to lower my arm assy to put them on. I had to lower it enough where I could only use one of the arm lock screws, the other was too low.
So, I started measuring stuff, and found the belt grizzly sent me is 76" long. The ones I ordered are 72", as they should be.
Did they send me some weird longer belt, because I ordered the 10" wheel?
I don't get it, I don't see 76" belts anywhere on the net, but I promise I have one.
Anyone?
I just bought a 2x72 Grizzly grinder with a 10" wheel. I set it all up with the provided belt, no problems.
I ordered some other belts for it and found I had to lower my arm assy to put them on. I had to lower it enough where I could only use one of the arm lock screws, the other was too low.
So, I started measuring stuff, and found the belt grizzly sent me is 76" long. The ones I ordered are 72", as they should be.
Did they send me some weird longer belt, because I ordered the 10" wheel?
I don't get it, I don't see 76" belts anywhere on the net, but I promise I have one.
Anyone?