3-finger-knife

JensJ · Oct 27, 2003

Hi folks,

I think this is my first post in this gallery...
just finished a small 3-finger knife.

specs:
5.7 in OAL
2.6 in blade of 3.5 mm RWL 34
Handrubbed to 1200 grit

Blade is one side flat ground, handle is dyed and stabilizied maple.

Comments welcome! Thanks for looking,
Jens.

zombiehunter · Oct 27, 2003

Your stuff is always cool, keep it coming!

-Jared
J.M. Place Handmade Knives...

Keith Montgomery · Oct 27, 2003

What a nice looking little knife. I like it a lot.

Robert Hankins · Oct 28, 2003

Welcome!

JensJ · Oct 28, 2003

Thanks

Rugger · Oct 28, 2003

Ausgezeichnet!

Chiro75 · Oct 29, 2003

Gorgeous. I don't know if anyone else knows this or not, but Junkers does this all with hand tools (files and such). His attention to finish is great considering it is all done this way. I do it the same and his finish looks ten times as good as mine, so I know he is putting serious hours into this work. Well worth it, but we need to get this guy a grinder!

JensJ · Nov 3, 2003

Hi Steve,

yes, go ahead, buy me a grinder

Thanks for your comments, I was going to mail you the picture, but forgot...

Jens.

Manji · Nov 4, 2003

very nice, keep up the good work!

ExamonLyf · Nov 8, 2003

Excellent work..., keep 'em coming!

Protactical · Nov 8, 2003

Jens, what kind of stamp do you use?

JensJ · Nov 9, 2003

@Protactical: no stamp, the mark/name is engraved...not by me, but by the knifemaker who also does the heatthreat for me. He uses one of those 'copying engravers' (don't know the correct name), so he can make it in different sizes, using the same pattern (on this one, the engraving is a bit large).

Jens.