3 new to me vises

Joined
May 18, 2014
Messages
546
I picked these 3 vises up today for $25 total.Ihave been looking for an X/Y sliding vise for a while so probably would have paid $25 for the bigger one, but they offered all 3 for it. I can't tell what brand it is though. It looks like the first 2 letters are DE but can't tell past that. The smaller sliding one needs a new handle and needs the screw cleaned up. The bigger and the machinist (a Brink and Cotton) both open and close completely.
image0.jpg
 
You did good. Use the X/Y vise with an end mill in your drill press to cut the slots for the magnets.
 
Back
Top