5/64" Machined Hex Driver

[jjg6319]

If you like to take your CRK knives apart to maintain them then check out this 5/64" machined hex driver:

http://www.horizonhobby.com/machined-hex-driver--red:-5-64-dyn2913

This has a machined tip that fits the allen screws on the scales.

The CRK plated allen wrench is slightly oversized since it is plated. The machined tip is a nicer fit and you don't have to make sure it is seated.

I bought mine at a hobby shop and I have used these before for other hobbies. I just though I would pass it along if you like having nice tools. They compliment the CRK knife very well.

 

[JB in SC]

MIP/Thorp makes the best driver on the market, especially in the smaller sizes. Wiha is plenty good, I've never had an issue with their wrenches.

 

[Padron26]

I actually use a 2mm instead of the 5/64. The 2 fits alot better and i dont have to worry about rounding off another screw.