710 Centering Issues - Can it stay centered?

[MikeLuke]

Hi everyone,
I was wondering if you could help me out. I recently got 710 in d2. Sharp as a razor straight from the box but the blade was a bit off center. I centered it (loosen the screws, push the liners in opposite direction, tighten them, blade centered). The problem I have is after a week or two of light use it goes off center again. Screws are tight (very tight I would say). Any solution for the blade to stay centered? Thank you.

 

[CelticCross74]

Since the liner trick isnt working try just simply loosening the pivot all the way, push and hold the blade to the opposite side from which it was off center to, screw pivot back in TIGHT all the way, release blade and loosen pivot to where it is just loose enough to avoid lock rock. The blade should be centered or very close to it. Worked for me on my 710 after doing the liner trick etc. Once I saw that the pivot method worked just fine I repeated it with Loctite so the pivot wouldnt start backing out with use. Worked perfectly. Its been weeks since and I have EDCd the knife many times. The pivot has not backed out at all and the blade is still centered.