810 thumbstud question?

BJJKnifeGuy · Oct 10, 2014

I love the 810, I am hoping to buy one to edc today. I also love wave modding just about everything, is it possible to remove the thumbstud so I can add a zip tie? Thanks in advance

Akcir · Oct 10, 2014

Just grab each side with a small wrench, socket, pliers etc and unscrew it.

Icky Thump · Oct 10, 2014

3/16 socket, I believe ..

macknife12 · Oct 10, 2014

It's a Torx. I remove mine to sharpen.
Cheers

macknife12 · Oct 10, 2014

You would be looking at one very small zip tie, unless you are going to drill. It's a small hole.
Cheers

Icky Thump · Oct 10, 2014

macknife12 said:
It's a Torx. I remove mine to sharpen.
Cheers

thats right, #6 Torx..

I use the 950 studs on many...forgot they are not standard equipment on the 810..

macknife12 · Oct 10, 2014

^^They look comfy.
Cheers

WCEDC · Oct 16, 2014

Sick photo.
Yeah, get two T6 drivers (Torx) from harbor freight or something. Each kit cost $3... Take the thumbstuds off that way, so that you don't scratch, mark, or completely chew them up with pliers.