Hello, I'm relatively new here a this forum, but I have been making knives for about 7 years. I am a sole authorship maker, I do everthing in-house from design to heat treating to finishing.
I thought I post a recent liner lock folder that I completed.
Specs are:
3 inch CPM 154 CM drop point blade with a hand rubbed finish
7 5/8 overall length
black G10 1/8 thick on the non-locking side
locking side is 440C 3/32 thick with a heat treated locking bar
.063 black G10 on the locking side
Comments are welcome.
Hope you enjoy
Jason
www.clarkcustomknives.com
I thought I post a recent liner lock folder that I completed.
Specs are:
3 inch CPM 154 CM drop point blade with a hand rubbed finish
7 5/8 overall length
black G10 1/8 thick on the non-locking side
locking side is 440C 3/32 thick with a heat treated locking bar
.063 black G10 on the locking side
Comments are welcome.
Hope you enjoy
Jason
www.clarkcustomknives.com
Attachments
Last edited:
