A new folder

[JTClark]

Hello, I also posted these pictures over at the knifemakers's gallery. I'm relatively new here a this forum, but I have been making knives for about 7 years. I am a sole authorship maker, I do everthing in-house from design to heat treating to finishing.
I thought I post a recent liner lock folder that I completed.
Specs are:
3 inch CPM 154 CM drop point blade with a hand rubbed finish
7 5/8 overall length
black G10 1/8 thick on the non-locking side
locking side is 440C 3/32 thick with a heat treated locking bar
.063 black G10 on the locking side
Comments are welcome.
Hope you enjoy
Jason
www.clarkcustomknives.com

 

[Lorien]

you know, that is a very good design. Could be tweaked and cleaned up a little, but the essence of the design is very strong.:thumbup:

I also went and checked out your website, and was impressed with all your dovetailing and by your prices.

I'll bet that you'll be making a career out of this soon enough.

 

[Khemist]

Hey Jason- Good looking work! Really like the lines on that knife, simple and utilitarian looking...the perceived "roughness" could be cruddy image compression resulting in some low-res pictures, kinda jaggy...get some better pictures of these bad boys, they deserve it...

You're prices are refreshing, good luck in your endeavors!

 

[JTClark]

Sorry, I grabbed the wrong photos
The pics in the knifemaker's gallery are cleaner.
But, I get them to post here.