Hoping someone monitors this forum from Cold Steel.
Constructive feedback: Recently purchased the AD10 and when I went to sharpen, I noticed an asymmetric edge. One side was ~20/1 degrees and the other was closer to 25/6. Not a huge deal, but made it a challenge to sharpen correctly, but I eventually got there. Glad the S35VN is a bit easier to sharpen.
Might want to check on the QC coming out of your Taiwan plant, I assume this wasn't intentional.
Constructive feedback: Recently purchased the AD10 and when I went to sharpen, I noticed an asymmetric edge. One side was ~20/1 degrees and the other was closer to 25/6. Not a huge deal, but made it a challenge to sharpen correctly, but I eventually got there. Glad the S35VN is a bit easier to sharpen.
Might want to check on the QC coming out of your Taiwan plant, I assume this wasn't intentional.
Last edited:
I'm sure that wasn't intentional.