any interest in a volt III?

iamtoast · May 16, 2011

missed the volt. Stupid baby food bills, sigh. The speedform II is a noce g10 version with great steel at a reasonable price. Would anyone else care to see a volt III built around that premise but closely honoring the original design in terms of size and lock type? I would love one.

RAGS · May 17, 2011

Count me in. I would love one also

presz · May 17, 2011

Sounds like a winner!

A nice big run please. 1000 to 1500 makes them a lot easier to get.

rororo64 · May 17, 2011

Im down like Charlie Brown, I really like RJ's designs.

Flashpoint · May 17, 2011

I'm surprised they didn't do this in the first place.

rororo64 · May 17, 2011

Id be fine with some 3D G10, with a liner lock, or perhaps their new "Sub-Frame Lock" thats going to be on the Knockout, with a steel better than 8Cr13Mov, made in the USA and is the same size as the original Volt

wait(processing mental image)... Oh my mother of God, that would be friggen amazing... Please Thomas, make this happen...

RevDevil · May 18, 2011

I already asked Thomas and he said no plans.

RAGS · May 18, 2011

RevDevil said:
I already asked Thomas and he said no plans.

Hey, ya never know.If enough people chime in and show interest,they might change their minds.

mikehopkins · May 18, 2011

Oh man! Stone Washed S30V..G10! Blade just under 4in. Would put my jeep up for sale to buy one. Please do.

rororo64 · May 18, 2011

Id be fine with 14C28N, however S30V or Elmax would be pretty nice

Maybe make this the new Blur with the different steels?

I hope there is enough interest in this folder...

gundude73 · May 18, 2011

that'd be sick. 4" of ELMAX with a G10 handle incorporating a titanium subframe lock.

sounds like a winner.

kneedeep · May 19, 2011

I'd love another shot at a full sized, high end Volt. I missed out on the original.

nls8520 · May 21, 2011

kneedeep said:
I'd love another shot at a full sized, high end Volt. I missed out on the original.

I agree with you. I would like to see another run of the exact original Volt.

thegeek574 · May 22, 2011

Sounds great. I wouldn't mind if they did a few retro runs for stuff like the ZT 0500 or the volt. maybe a bit higher price, better steel, 1000 units. even better, give the rights to a smaller company as a collaboration. just saying. that would be awesome.

iamtoast · May 24, 2011

I guess I would be looking at a mid-level price point. s30v etc would be ok or cpm-d2 composite butI would really like 3d g10 and a frame or sub frame lock.

Apec · May 24, 2011

I'd like to see one, though not with CPM-D2 in the spine of the composite blade. I'd be fine with something like the ZT 0350CB, 14C28N with an Elmax edge, even though M390 in the original was cool.

presz · May 24, 2011

Volt 3 should = Tyrade G10. That is the same blade and size just not Ti.

And street price should be about $70 like I paid for my G10 Tyrades would be real nice.

Ok I would pay $80.

iamtoast · May 26, 2011

The cpm-d2 would be the edge but a little higher end would be great. The overseas version with the linerlock seems too different to me to quench my desire for the Volt.