Any Sources for Thicker than 1/8 inch Carbon Fiber?

I got a piece about a foot and a half wide by 3 feet with a chunk out of the middle if you are interested. By the way, it is almost a quarter inch thick and came off an Indy 500 car...I kid you not. Could email you a pic if you might be interested. Beautiful stuff.

Hank Hammond
 
Roger....Chuck Bybee at www.alphaknifesupply.com
has what you are looking for and he is a super guy to deal with
 
Roger, how wide do you need it?????? I got some cut off piece from the rudders that are only 3/4" wide, but over a 1/8" thick. :confused:
 
Hank, I am going to send you an email as soon as I finish this post.

Nathan, tnx for the link. I never thought to check him. I will.

IG., fraid its to narrow. I need > 1 3/4 inch wide. Tnx a bunch though.

RL
 
You may have already thought of this but if you have large pieces of 1/8" CF you could intentionally offset the pattern so that it goes one way on the bottom and the opposite on top. When you shape the handle it might look interesting. Just a thought.

Sean
 
You must log in or register to reply here.
Back
Top