Anyone experience with the Magnum Pohl Design *440 Stainles Steel Dagger??

Joined
Feb 5, 2005
Messages
78
I have thrown my Magnum for couple a days and I it rocks, to bad that my blade seems to bend a little at the point of impact. I guess the training board is to hard or my bladepoint is to thin. Does anyone have a good advise for a good quality thrower, please let me know!

Thanx in advance.
 
Does anyone have experience with throwing the Buck Alpha Hunter, That knive is one of my favorites, but I don't want to throw it before checking if anyone has experience throwing with it.

Thanx in advance.
 
You would be much better off with a real, purpose-designed thrower. They are not generally sharpened, so you can practice blade and handle throws, and what handles there are (if you choose a model with a handle at all) is usually something simple like riveted leather that won't be damaged by a non-point hit. They are usually made of a type of steel that is shock resistant, like some type of spring steel, so they won't snap if they hit wrong. They are, as well, balanced for proper throwing. You would do well to buy three or so, so you can practice to get your releases and spins consistent from throw to throw, without having to walk up after each throw. Now, I have a trio that I picked up at a show out here, and they were sold by the guy putting on a throwing exposition at the show. They are from Bob Karp, I believe. Sixty or seventy bucks for the set, and they look like they'll keep going forever unless you use big boulders as a backstop.
 
Thanxs for your reply. The problem in Amsterdam-Netherlands is that throwing Knives are forbidden by law. So you can't buy them in a shop. They sell boot knives but most of the time the quality is low. But you are right, throwing with a real throwing knive is the best solution.
 
Wellll, silly me, I didn't check to see where you were writing from. I spent my senior year in high school (more than twenty years ago now though, so my Dutch is WEAK!) in your fine country, but I don't remember the throwing-knives law. I do remember joining a bow shooting club so that I could shoot something. I am familiar with silly laws though, as I live in the "People's Republic of California". :rolleyes:
 
You want a knife that is made from plain carbon steel, not stainless. You want the blade hardness down in the low 50's RC. You also need it to have a wide and strong tang running through the handle. If you are allowed to own a bayonet you could cut off the handle and just throw the blade. Bayonets are a good tough alloy.
 
Thanks for the informative reply's! I will look out for tough alloy blades and keep ya'll informed with my progress, Thanx a lot!
 
If you have legal issues with "throwing knives" one thing you could try are carbon steel "blade blanks". These are basically the steel part of a knife kit. You can get solingen carbon steel blades that are pretty tough. If you are ambitious you can also reduce the hardness of the blades by baking them in your oven for about and hour at 550-degrees F. Here is a link to some possibilities.
http://www.trackofthewolf.com/categ...tId=9&subId=56&styleId=199&PageSize=10&Page=2
http://www.trackofthewolf.com/categ...tId=9&subId=56&styleId=199&PageSize=10&Page=3

I would suggest one of the following models:
(page 2) Blade-5963
(page 2) Blade-6076
(page 3) Blade-Natchez

You may need to sand the handle area a bit or you might want to put a little epoxy on the handle region and wrap it with rope or leather laces.
 
Back
Top