anyone using a ZT 0300?

B

Billmanweh

Joined
Sep 5, 2002
Messages
606
Just wondering if anyone is carrying one and how you like it?

Also, anyone know when I can pick one up for less than retail?
 
Billman said:
Just wondering if anyone is carrying one and how you like it?

Also, anyone know when I can pick one up for less than retail?
Click to expand...

I have both ZT200 and ZT302 -
http://www.bladeforums.com/forums/showthread.php?t=419026&highlight=ZT302
http://www.bladeforums.com/forums/showthread.php?t=410660

On my opinion this is best two knives awailable (to awoid misunderstanding - best among semiproduction knives on American market). Both are almost perfect from my point of view - just different styles. I useed it around house and office - not too much, but no issues so far - boxes, pencils... ZT200 need to fix liner lock - it was too sharp and hurt my finger, but I fixed it in no time with small file.

Minor consern - clip at some positions scrued to G10 not to metal and I afraid it may not hold it very well. However I removed clips anyway, so it may be just my imagination - I had no problem like this.

But in general this knives take best from Ken Onion and Mike Strider and I may say it is best Onion as well as best Strider. I just love both knives equally.

As well as price - I really try to find someone in the Internet, all aswer - TAD Gear only. I check with local retail store, they contact Kershaw and answer was again TAD Gear only. It looks like TAD Gear for some reason is only seller of this knives...

Thanks, Vassili.
 
I love the design of the ZT 300. its the only striderized ZT and it s a frame lock. Ummmmmmm.......... Frame locks
 
Got one early july,its heavy duty for sure. massive frame lock, really like the 2 tone coyote g10/ti handle.blade is real wide,perfectly made in every way,but a bit heavy to carry all the time. small pocket clip is nice,too.havent seen it for less than the asking price, used is sometimes more.
 
nozh2002 said:
Minor consern - clip at some positions scrued to G10 not to metal and I afraid it may not hold it very well. However I removed clips anyway, so it may be just my imagination - I had no problem like this.
Click to expand...


Vassili

The clip on the 0301/0302 is not screwed to the G10. There are threaded insterts on the inside of the handle.

Tim Galyean
Zero Tolerance R&D
 
Hey Tim,
I just got my ZT302 today and I must say that you guys have done an outstanding job in assembly of these pieces! The only minor flaw was that the Hinderer disk needed a little tightening as it rattled.
I've got a question though: The titanium lockbar clearly has a ball detent in it, but as far as I can tell, the blade does not have a hole in it for the ball! Is this an oversight or was it intentional?
 
You must log in or register to reply here.
Back
Top