ASH1 vs. Frying pan

[Snakebreaker]

Could only do so much at the apartment without making too much noise. Will finish chopping this in half this weekend when I get back out to the property. Again.....I can run my finger nail down the blade and there are positively no chips, dents or rolls. Notice all the chops into the edge of the pan too. Its a BADASH!!!!!

 

[trukreltrog]

Outstanding,,,

 

[echaraska]

Nice! Don't know if I could bring myself to do that. Really cool though!

 

[Nframe357]

Holy freaking cow! That's impressive! May I ask how? Did you hammer it through to start?

 

[zmbhntr]

Hmmmm... It's gong to be difficult to make pancakes in that pan now.

 

[AValenz]

That is one big ASH - HOLE

 

[Warbow150]

Is that an aluminum pan? How's it handle a cast iron skillet?

 

[Noxious Fumes]

Wouldn't try that in cast iron!

 

[RobStanley]

Awesome!!!!!

 

[zakjak221]

Pan had it comin....
Ash rules!

 

[resinguy]

58 Rc hardened steel vs dead soft aluminum. No contest. But fun. :thumbup:

 

[Wicked Sharp]

Now..., roll it up with your bare hands, and slice it like a California roll.

 

[jstn]

Why? Because you can.

 

[benzology]

Quality. Just quality.

 

[tinfoil hat timmy]

It looks like I found a different way to strip my blades
Looks like more fun too.

 

[Rasmus80]

58 Rc hardened steel vs dead soft aluminum. No contest. But fun. :thumbup:

Had the aluminium been alive, on the other hand...!

 

[358]

58 Rc hardened steel vs dead soft aluminum. No contest. But fun. :thumbup:

Indeed. I have some copper-weighted stainless I bet you wouldn't tackle.

 

[tuica]

Nice bit of panache. I had to say it...;-)

 

[lazy otter]

Snake buddy you really hold a grudge against frying pans! This is Atleast the 2nd one I know of you killed! Good job brother!

 

[Snakebreaker]

Lol!!!! Thanks for all the comments. It is aluminum but its thicker and stronger than hell. It took full power stabs to penetrate it and baton and chop into it. Once I had the blade started into it.....I would pry back and forth until there was enough room to baton. It was certainly no easy feat!

Again......I couldn't go at it like I wanted to because it was pretty noisy......but that will change in a day or two when I'm back at the property.