Backspacer for an Ontario RAT 1...

[BOOMER52]

I machined the small Anso patterned tiger stripe G10 scales to replace the OEM scales a couple weeks ago but felt that the knife needed a backspacer. I finally decided on a flush large cog design where the cog trough frequency is such that they avoid dipping too close to the standoff locations. Machined out of black G10... and a bit difficult to get good photographs of...

 

[OHALLUM]

Hey, I like that! It looks fantastic, and you did a excellent job on it. Bet your neighbors don't have one like that! One of a kind is very rewarding when the project turns out just right.

Blessings,

Omar

 

[bpeezer]

One of the nicest looking mods I've ever seen, very very cool!

 

[pjwoolw]

That looks pretty snazzy! Nice job for sure!

 

[KP513]

null

 

[Van Fitzgerald]

Beautiful Job. Do you make and Sell these?