- Joined
- Mar 7, 2007
- Messages
- 3,951
Finally got my new Barkies!! Bravo 1, Mikro Canadian, and firesteel, all in big horn sheep. The Bravo 1 was off the shelf from DLT, and it's a first production run. The Mikro and the firesteel had to be made, and Mike Stewart and his crew did a spectacular job. They even used the mosaic pins, which I had never seen before.
I don't know if Larry from DLT sent Mike the Bravo 1, or a picture, or what, but the horn on the Mikro has the same coloring and stiations as the Bravo 1.
This is my first kydex sheath, and I'm not sure if I like it. It is good and secure, and looks great, but I'm not yet comfortable having to jam that ultra-sharp knife into it. I don't think it'll bust through the sheath, it just doesn't feel right having to push so hard. Is there any possibility of trimming back the opening just a bit to give it a little freedom?
I don't know if Larry from DLT sent Mike the Bravo 1, or a picture, or what, but the horn on the Mikro has the same coloring and stiations as the Bravo 1.
This is my first kydex sheath, and I'm not sure if I like it. It is good and secure, and looks great, but I'm not yet comfortable having to jam that ultra-sharp knife into it. I don't think it'll bust through the sheath, it just doesn't feel right having to push so hard. Is there any possibility of trimming back the opening just a bit to give it a little freedom?
