Benchmade Bedlam Reassembly woes

[ronin.graves]

Does anyone have any experience reassembling a Bedlam 8600?

Do to circumstances beyond my control, I have to disassemble one and have all the parts accounted for except for a small tiny aluminum pin and a small black metal sleeve. Both seem to go nowhere and I’m starting to think it’s just a fancy warranty void sticker.

Would be eternally grateful if anyone had experience I could leverage.

Metal sleeve is about 1/8 inch x 1/8 inch. Small metal rod (pointed on one end) is about 1/4 inch long.

 

[ronin.graves]

Think I figured it out. The pin is a support that goes under the middle spring support for the rear spine lock. The metal colar goes around the middle of the top most spacer above the blade pivot. I maybe would have sent it in, but I was under a tight time constraint. I’ve also heard mixed things about their service. Well hopefully I at least provided some noob entertainment for the forum.