I noticed some rust on my BenchMark Viper so I pulled out all of the guts (the blade and spring assembly are held in by 3 pins) and cleaned it up but now I can't get it back together. In particular the I cannot figure out how to get the spring assembly back into place. I've spent hours on this.
Am I going to have to split the case? (The case is essentially an integral, glued together out of fiberglass.). If so, has anyone had any experience splitting the case on a BenchMark Viper?
I've searched the entire forum and haven't seen anything about assembly/disassembly of rolox knives.
Any help!
Am I going to have to split the case? (The case is essentially an integral, glued together out of fiberglass.). If so, has anyone had any experience splitting the case on a BenchMark Viper?
I've searched the entire forum and haven't seen anything about assembly/disassembly of rolox knives.
Any help!