Bended knife

[Yvanovic]

Hello, just registered to show you what happened and if I can do something.

My knife "bended" see pictures.

Do you think I can do something to get it right?

Facebook

www.facebook.com

 

[MolokaiRider]

Bend it back, and pray it does not snap.

 

[Yvanovic]

Will add photos on my FB and add a link........ seems this is the only way

 

[justjed]

Carbon steel MIGHT bend back, carefully! Stainless blade will likely break. Good luck...

 

[Arathol]

Will add photos on my FB and add a link........ seems this is the only way

Facebook sucks......use Imgur and post the BBCode link here.

 

[Yvanovic]

Facebook sucks......use Imgur and post the BBCode link here.

Tries, asking for a phone number........arghhhhhh No way. thans I will try FB

 

[Yvanovic]

Tries, asking for a phone number........arghhhhhh No way. thans I will try FB

.... and I know it sucks, I have only 2 "friends" and I publish nothing.

 

[Srtr]

Now you can cut around corners.

 

[toker]

How did it get bent in the first place?

 

[Yvanovic]

Bend it back, and pray it does not snap.

For your attention, thanks.

Facebook

www.facebook.com

 

[justjed]

Thank you, the pictures were helpful! Kitchen knives are generally a little softer than hunting or camping knives. With care, that might be made reasonably straight again.

 

[Yvanovic]

Thanks you all, removing my FB pictures.

 

[Yvanovic]

Now you can cut around corners.

Yup, actually when I pull back the knife like with peppers or mushrooms, they just go out of the spot by themselfs...

 

[KenHash]

Did anyone capture the photos before they were removed in 43 min after the first post, so I could see it?
There is a tool for correcting bent kitchen knives. But without seeing the knife don't know if it would apply.

 

[Yvanovic]

Did anyone capture the photos before they were removed in 43 min after the first post, so I could see it?
There is a tool for correcting bent kitchen knives. But without seeing the knife don't know if it would apply.

I published again.... hope the link will work, quite long...

Facebook

www.facebook.com

 

[KenHash]

I published again.... hope the link will work, quite long...

Facebook

www.facebook.com

OK thanks. I didn't know it was at the tip.
There is a tool called a Hizumi-Bo that is used to correct warping
but not at the tip. Never mind.

 

[Bob Denman]

Buy a new knife. Everybody needs a reason to buy a new knife...