Black Hart Khukri

[Hankins]

Black Hart Khukri

This wound up with one of those finishes that you tend to "Look Thru" along with some MyKarta for the scales. Trying to decide if this gets to be a User/Tester or goes to some Evil Doer out there in the shadows. Gets a convex edge tomorrow and with a bit of a Buff should set it off nicely.
What do you think?
Here is a better pic

 

[kevin adams]

nicely done!bet the saw tooth was a pain to do

 

[grindonyou]

Very nice blade it should be a best seller . Was it a pain to make ?

 

[Hankins]

There is a definite challenge to doing a Khukri with a Convex grind...
Saw side is a hollow grind done on a 2" wheel. Will be a ripper for sure if the top is sharpened!