Blackwood fighter W-2 DH

S

Shawn Ellis

Joined
Feb 6, 2006
Messages
243
59.jpg

This is a little fighter i finished the other day.
Also made of some of Don hansons w-2 Good stuff.
The knife is sitting on a little stand that I made at work
It's supposed to look like bambo.
www.shawnelliscustomknives.com
 
Sleek, Shawn. That handle looks really comfy. Is that a tiny bit of engraving on the Pin?

John
 
Thanks Kevin & John, I wish that was some engraving on the pin, It's a mosaic pin copper & stainless.
I have a few hunters to finish, Then it's on to some damascus Bowies
I have one blade that's going to be too cool, dbl turkish twist with a W pattern
somthing in line with the Mamba.;)
John looking forward to visiting with you @ Blade.
www.shawnelliscustomknives.com
 
Shawn this is another Beauty
cant wait to see the blade show knives
 
I like this knife a lot. I'm starting to like blades that are around seven inches, and blackwood is one of my favorite woods. Does the blade have a very slight recurve, or am I seeing things?
 
that looks great! I agree that it looks very balanced. I like it.

Trevor
 
Don's W2 is being put to good use all over the place. :thumbup: Nice work, Shawn.

Roger
 
That is a really neat blade profile:thumbup: I have found that Don's 3/4" W2 round bar really likes to be pounded out into those 5-7 inch clip point blades:D
 
Thanks Guys , Kyle I'm not sure if I'll go or not It depends on how much I can get done before Blade.Theres a Browning cutting challenge and Bladesports cut all in the same day here in mtn .view the week before or the week after?The pineywood hammer -in , And I'll try to go turkey hunting somtime so
it seems mighty slim. But time will tell.
www.shawnelliscustomknives.com
 
Beautiful piece Shawn, don't you love the way Don has that W-2 trained to almost shape itself. :D

Bill
 
Very very nice, Shawn. You're cranking out some really great knives.
 
You must log in or register to reply here.
Back
Top