Blade off center 800SBT AFCK

uxo2

uxo2

Gold Member
Joined
Oct 3, 2013
Messages
5,445
Question


I recently found my forgotten AFCK with ATS34 steel.

Even new, it has always been off center and I just lived with it
as I thought it was normal and as long as it worked I never cared.

Well. Flash forward years later and know I know a lot more and it annoys me.

Close or open and it scrapes the liner

Is there a way to tweak it back? Like fixing a PM2.


TIA.
 
Last edited:
unless the blade is warped or bent, I can usually get it centered up by playing with the screws

loosen all the screws and go around and snug them up a little bit at a time... kinda like lug nuts on a wheel.

be sure and loosen your clip screws also... sometimes if they are torqued too much they'll make it off center..
 
Nope.still Off center

This one is a pain.

But good news. Called the factory. And It will go in for re-centering.

Basically a Spa treatment:)
No new blade as they are GONE.
 
Last edited:
You must log in or register to reply here.
Back
Top