Blade rehardening/regrinding

Thanks! Does he reharden too? I've been looking at the regrind pass around thread, and he does really nice work.
 
I can't say for sure whether he does rehardenings, but he IS a knife maker... I think he could do something like that.

You could also check out STR on our forum here. He does all kinds of work as well.
 
before getting the blade rehardened i would have it annealed and ground first. i put a satin finish on 2 knives for gator97 that were rehardened to around 63rc and it the factory grind lines were extremely difficult to get out. he did 1 by hand which he said took him a long time to do.
 
You must log in or register to reply here.
Back
Top