Blur Clip

[shandrydan1]

I'm having some issues with the clip on my Blur being too tight. When I pull the knife out of my pocket it literally pulls my pants leg up an inch or two before it lets go. The lower 3/4 of the clip are fine. Its just the last 1/4 near where the clip attaches that it gets tight. The inserts are also a lil rough on the inside of the pocket because of this. Any idea on what I could do to fix the problem or is it something that just happens with the Blur?

 

[svrider3]

Just bend the clip out a little at a time till it feels right to you. No need to take it off the knife.

 

[rororo64]

Get a new lowrider clip from STR, or you could try bending out near the back, and bending it in near the middle if that makes sense.

 

[EricV]

Take some stiff paper, fold it over a few times, and put it under the clip (as if the paper were your pocket) that will bend the clip just a little bit and you won't have to worry about breaking anything. If its not bent enough, fold the paper more and try again.

 

[gundude73]

in my experience kershaw clips come tight from the factory. just remove, bend, and reattach. easy as 1,2,3 :thumbup:

 

[shandrydan1]

Thanks for the ideas. I've got plenty of cardboard at work so I will try clipping it over that first and if that doesnt work I will remove the clip and try bending it.