- Joined
- Jul 4, 2009
- Messages
- 1,910
Just got the Batman. Nice knife for the money and certainly a bit "different".
Liner lock could be a tad easier to get at, but not bad. Not like you're going to opening and closing this one 10 times a day.
Blade sharpness is "ok". Could be a bit better considering how hard it would be for most (or me really) to sharpen this type of blade.
Only real negative I have is that the tang, or rear of the blade, potrudes out of the bottom of the frame about 1/16" when open and is almost sharp. Would have been nice if it was ground even with the frame.
Blade is slightly off center when closed, which leads to my question.
What the heck kind of tool does one use to adjust this? The pivot pin looks adjustable, but has a 5-hole head I'm not familiar with.
Liner lock could be a tad easier to get at, but not bad. Not like you're going to opening and closing this one 10 times a day.
Blade sharpness is "ok". Could be a bit better considering how hard it would be for most (or me really) to sharpen this type of blade.
Only real negative I have is that the tang, or rear of the blade, potrudes out of the bottom of the frame about 1/16" when open and is almost sharp. Would have been nice if it was ground even with the frame.
Blade is slightly off center when closed, which leads to my question.
What the heck kind of tool does one use to adjust this? The pivot pin looks adjustable, but has a 5-hole head I'm not familiar with.
