Boot Skinner/EDC drop point - Jeans (and ostrich!)

[navman]

This Boot Skinner has "jeans" scales (blue linen and natural linen micarta) with copper hardware and a stainless/CF Trinity decorative pin. The lanyard tube is surrounded by natural micarta. Ground from1/8" thick CPM S90V on a 24" radius platen and hand satin finished Heat treat by Peters' to 61.5 HRC. BTE thickness is .008 (geometry cuts)! Tapered tang (.020") with a 3.25" blade, 7.5" OAL. Spine is rounded and has a short section of 30LPI thumb serrations. As I mentioned in the CPM thread, I am now marking my CPM S90V with the steel type to differentiate between any new material that I may use in the future.

I am very happy with the sheath. It is brown leather with a blue ostrich leg inlay and blue stitching to compliment the knife.

 

[jfk1110]

Damn fine work...........

Always a pleasure to see what you have made.....