- Joined
- May 2, 2004
- Messages
- 6,848
Bethel Ridge Forge is doing all our sharpening and edge profiling, along with primary bevel grinding after heat treat on our new wet machine. This allows us to grind super thin primary bevels at set angles as well as sharpening at consistent repeatable angles.
The blades being sharpened in the video were done @ 15 dps our ERU sharpener being used to remove the burr, followed by a 1 degree micro bevel increase. The resulting edges should not be tested by shaving hair off your arm
[video]https://youtu.be/lCBUa4CAE4c[/video]
Happy to answer any questions, Fred
PS Our good friend Jeff Lawrence is sharpening his knives in this video.
The blades being sharpened in the video were done @ 15 dps our ERU sharpener being used to remove the burr, followed by a 1 degree micro bevel increase. The resulting edges should not be tested by shaving hair off your arm
[video]https://youtu.be/lCBUa4CAE4c[/video]
Happy to answer any questions, Fred
PS Our good friend Jeff Lawrence is sharpening his knives in this video.