Buck 891 ?

[Xr6x]

I thought I owned every hex wrench or bits I would ever need. Apparently not. Does anyone know what size wrench is needed to remove the screws holding on the scales on the newer 891 knife? I’m assuming the screws are probably the same size as on the compadre? Thanks in advance

 

[jbmonkey]

torx 10 seems to fit in.

 

[Xr6x]

torx 10 seems to fit in.

Thanks jb! What happened is one of the scales had a little nub sticking up just past the start of the lanyard hole. Thought I would take the scale off to remove it. I ended up scoring it and just basically snapping it off from the other side. I didn’t think to try a Torx . Looked like an Allen oh well next time. Thanks again jb