Buyers Opinions Please

Epsilon

Epsilon

Joined
Jan 15, 2002
Messages
430
I am curious to know what the custom buyers think of this knife I made. http://www.blacksheepforge.com/halcyonproject.htm Lemme' know. :cool:

SPECS: CPMS90V, HRC59 (I do all my own heat treating) Fully Convex blade/edge. Ground from 1/8" stock. 180 grit, plus fine scotch-brite finish. Blade tapers. Spine beveled. Flat, full tang. Front, "reverse" bevel is sharpened full convex as well. Blade is 4", handle is 4.5". Blade width max 7/8". Handle thickness approx 3/4". Black linen micarta. Single mosaic pin. Copper thong hole tube.

-Jason
 
I like this knife very much. It would be nice to get a look at it from the tip looking straight on. I don't think I have ever seen a knife that had a more obvious convex grind.
 
Ah yes, just as I thought. That blade has quite the pronounced convex grind. Looks like it would be fun sharpening this one.
 
You must log in or register to reply here.
Back
Top