C.U.B. Master Karambit 5:11 Tarani

STR

Knifemaker/Moderator
Moderator
Joined
Aug 27, 2004
Messages
12,956
Ok this one up next. Once again I am impressed with the build quality of these Tarani folders. I don't know how this one compares in cost but I can tell you of all I've handled its top shelf. S30V steel, super nice fit and finish and smooth as silk with a rock solid lock up! What more could you want? Well, this guy that owns this one says, a Wave mod so thats coming up.

I'm tellin' ya though. Check out these 5:11 folders if you haven't paid any mind to them. They are probably some of the best cutlery I've seen from Taiwan productions in the way of folders.

Seen below is a before shot for ya.

STR
 
Well, so far this morning my back has allowed me to bury a cat, make four prySTRs and Wave this folder as well as repair another. I can't say my head is totally in it yet but the motrin seems to be doing the job at least.

This one turned out pretty good. This was the easiest grinding S30V of any I've made into a Wave. May have to to do with the thinness of it compared to others that have been sent to me. You can sure tell when it gets up above 1/8" that its a very wear resistant steel. Not so bad in this one though.

STR
 
STR...what would it cost me to have my Tarani Journeyman Waved? Its the same knife, with 154Cm steel and FRN handles...
 
$30 plus shipping

No its not the same one but close.

STR
 
Back
Top