- Joined
- Oct 3, 1998
- Messages
- 4,670
Camillus is about ready to ship the Talons! Here's a sneak peek at an actual production sample of the Talon. They have done an excellent job at reproducing Rob Simonich's design.
<center>
</center>
3.5 inch Talonite blade with grooved black G-10 scales fastened with Torx head screws.
<center>
</center>
A pic of the other side of the blade. Though you can barely make it out in this scan but if you look on the blade close to the tang, Simonich's buffalo logo is laser engraved on there.
Real nice factory piece! The sheath is by Blade Tech and is very similar in nature to the CQB-1 sheath. A mini Tek-Lok is supplied to carry the Talon in a variety of carry configurations.
Hats off to the Camillus gang and Rob Simonich for another top quality collaboration knife.
------------------
AKTI Member # A000005
Living life "on the edge"
<center>
3.5 inch Talonite blade with grooved black G-10 scales fastened with Torx head screws.
<center>
A pic of the other side of the blade. Though you can barely make it out in this scan but if you look on the blade close to the tang, Simonich's buffalo logo is laser engraved on there.
Real nice factory piece! The sheath is by Blade Tech and is very similar in nature to the CQB-1 sheath. A mini Tek-Lok is supplied to carry the Talon in a variety of carry configurations.
Hats off to the Camillus gang and Rob Simonich for another top quality collaboration knife.
------------------
AKTI Member # A000005
Living life "on the edge"
