Carry options for ESEE-6 and 3?

not-too-sharp

not-too-sharp

Joined
Jan 6, 2010
Messages
243
So I just got my new ESEE-6 in the mail yesterday,and had a few questions.:D

1st: I like my camp knives to hang a little low on my belt, should I go with the belt clip or the MOLLE back?

2nd: How big is the gear pouch attachment? LM Wave size?Altoids tin size? etc.

Also I have the MOLLE back for my ESEE-3, and for me it makes the knife a pain to get out from my belt because of the angle the molded sheath sits at when attached. Is there a way to remedy this?
Or am I the only one who has this problem?
Are there any after market sheaths for the 3?

Sorry for all the questions :o

Thanks in advance-Andrew
 
hi, i would go for the molle back and pouch, the pouch is altoids tin size and comes with one in it. i prefer the flexibility of the molle back on the belt, it flexs and moves with you instead of the rigid clip.

for the 3 you might try loosening the screws a bit and adjusting the angle then retighten them. i only use the boot clip on the 3.


take it easy
cricket
 
I can't answer most of your questions but...

Yes there are aftermarket sheaths for the 3.
Quite a few in fact.
They're largely custom or semi-custom though. The two i can think of off the top of my head are:
Shotgunner11 does Kydex. Sharpshooter Sheath Systems does a really nice looking leather one.
 
You must log in or register to reply here.
Back
Top