Case/Bose 07 collab

Charlie Mike

Sober since 1-7-14 (still a Paranoid Nutjob)
Knifemaker / Craftsman / Service Provider
Joined
Nov 1, 2000
Messages
28,365
This thing is beyond mother loving sharp! I shaved a 3"x6" patch off my arm with 4 swipes. Then my dumb ass wipes the blade off on my left shoulder to get the crap off. Very stupid... Cut through the sleeve of my shirt like it was air. Immediately felt it but it didn't start bleeding for 10 seconds. The pic below was taken between 26-30 hours after it happened and the cut is 1.5" long. I now understand what JAnkerson means when he says "air bleeding" sharp. The other pics are some BS from Capital One because I paid them off and told them to (figuratively speaking) go and f themselves. Made great test media. I am really looking forward to sending this off to the Valotten shop and have it converted to a D/A shield fired auto. I'm also having all the pins replaced with torx screws. Rainy said that would make his job easier. I'm actually carrying this in my right pocket (yes, it kicked my Reese/Emerson out) and it is amazingly thin (approx 1/2") compared to my expectations, carries very well loose in my BDUs. I'll be using it a bit before it goes under the knife though. This is gonna be a "heirloom" piece in my collection. Perhaps I'll have a Lifter or G2 case made for it.

Type Folder
Blade Clip Point
Blade Length 4-1/16″
Blade Steel ATS-34
Rockwell 57-59
Lock Lockback
Bolsters Stainless
Liners Stainless
Pattern Swing Guard
Handle Brown Bone
Closed Length 5-5/16″
Weight 6.4 oz
Origin USA

l_d179fd0decab40fd9fe34b72a62bc009.jpg


l_901672ac3599476abb2d882177c35434.jpg


l_1c3f9999fa804462ae87aa56b856833a.jpg


l_577a463150a54017b79fdbf011f0fa9b.jpg
 
[youtube]ERcqpwfeu90[/youtube]

Couldn't resist using the Art Bell music :p
 
A huge part of the reason to pay the amount of money the Case/Bose collabs cost is the f&f. You didn't mention the f&f much. How is it?
 
F&F... tighter than a frog's asshole!
 
Back
Top