Ceramic Rods

[william8]

Hi Does anyone know where you can buy just the ceramic rods on the internet the medium and fine? .. I should say the plain round type I would like not having to buy the whole system like the lansky,just to get the round rods. I've looked everywhere but have not found them yet. Thanks William

[This message has been edited by william8 (edited 05-20-2001).]

 

[The Magician]

If you are looking for the Spyderco sharpmaker rods you can get them from Knives Plus 1-800-687-6202 suggested retail is $11.50 so I am guessing they will go around $8. Good days,

------------------
Brian
The first knife was probably used to cut stuff.

 

[AlaChoctaw]

SMKW sometimes sells the round ceramic "steels", which are somewhat larger in diameter than those found in sharpening sets. www.eknifeworks.com

------------------
AKTI Member #A000934
"Always just one knife short of perfection!"

[This message has been edited by AlaChoctaw (edited 05-22-2001).]

 

[cpirtle]

A basic Crock is only $8 at Dicks, why not buy one of them and throw the wooden part away?

------------------

 

[Ed Gordon]

I have seen the rods advertised individually in A.G. Russel catalogs. You could check their website and give them a call. I think they were about $8.00 each...Ed.

 

[SIFU1A]

go to the sharpcenter at www.knifecenter.com, they have them.....

SIFU

[This message has been edited by SIFU1A (edited 05-21-2001).]