cheap Benchmades - 910BK, 910D2, 710, and 940BK

Status
Not open for further replies.
CapitalizedLiving

CapitalizedLiving

Joined
Dec 1, 2007
Messages
3,798
For sale are four Benchmade knives, all of which are users to some extent. The price is $80 each for any of them, including USPS Priority mail shipping and Paypal fee. CONUS and Paypal only, and no trades please.

710
This is the non-limited edition Knifeworks version in M390 Steel. This knife was carried and used a lot, and has a lot of scratches on the blade to show for it. There are also spots on the blade from plumber’s cement that dried on the edge and had to be sanded off. There are no dings, chips, or rolls in the edge or tip – you could polish the blade and it would be like new. The blade has been sharpened a couple of times and is fairly sharp at present. The blade is off-center when closed. The clip shows almost no wear. The handles are a little dirty… sorry about that. Comes with box, bag, and papers.

710-1.jpg710-2.jpg710-3.jpg710-4.jpg710-5.jpg
 
940BK
This is the Knifeworks exclusive (#228 of 300) with black anodized aluminum handles, silver titanium backspacer, and black-coated S30V blade. The handles have quite a few scuffs and marks on them, and the blade and clip have minor coating wear. This knife was also carried and used a lot, but only shows aesthetic signs of wear – it’s a true workhorse. No damage to the edge or tip. The blade is pretty close to the center when closed. Comes with box, bag, and papers.

940-1.jpg940-2.jpg940-3.jpg940-4.jpg940-6.jpg
 
910D2
The clip has some minor coating wear, the backstop and pivot screws have a lot of coating wear, the edge is what I would consider poorly sharpened (it came dull and I didn’t do it any justice), and there are scratches on the blade as shown. No damage to the edge or tip beyond scratches from me not knowing how to properly sharpen D2 steel (no chips, dings, rolls, etc - just scratches). The blade is pretty much centered when closed. Deploys smooth and locks up tight with no play (see pic for lock position when open). Comes with box, bag, and papers.

910D-1.jpg910D-2.jpg910D-3.jpg910D-4.jpg910D-5.jpg
 
910BK
The oldest of the old school Strykers. This has no backstop pin so the blade does not have a choil. Steel is ATS34. There is some minor rubbing on the blade coating – I couldn’t manage to successfully photograph them, but if you look closely when you get it, you’ll see it. No damage to the edge or tip and appears to still have the factory edge. The deployment is a little stiff – I tried adjusting the pivot pin but that didn’t change anything, so my guess is the Teflon washers are just old. It locks up tight with no play (lockup position shown in pic) and is a bit off-center when closed. Does not come with a box, bag, or papers.

The price is $80, including USPS Priority mail shipping and Paypal fee. CONUS and Paypal only, and no trades please.

910-1.jpg910-2.jpg910-3.jpg910-4.jpg910-5.jpg
 
Last edited:
mp sent withh question about oversea shipping ... sorry, i didn't read well your infos ...
let me know if you change your mind
 
Status
Not open for further replies.
Back
Top