Check out this out.. Tritium vial + Emerson mini cqc7

J

jefff

Joined
May 27, 2005
Messages
747
I pulled it off.. was wondering what to do with this little tritium vial from a key ring and seen a few butterfly knives with them in the handles so I put it in the back strap spacer of my little CQC7.. pretty nifty .. I still have to epoxy it in all the way .. I just have a dab of hot glue on the bottom to hold it in place until I run to the store to pick up some clear epoxy to cover the whole thing and clean it up some more.. ..

Thanks for looking..
picture0579bz.jpg

picture0620ov.jpg

picture0451ei.jpg
 
Thanks.. I just wished I had a better way to mill out the recess for it .. I just used a dremal and hogged through the nylon back spacer with a 1/16 flat grinding stone.. kinda a rough way to do it.. But it works, just not as pretty as it should be..

Maybe I can check around on the board and see if sometime I can get someone to make me a custom aluminum back spacer with a recessed milled spot to put it and make it look nice..
 
You must log in or register to reply here.
Back
Top